海康DS-7816N-Q1升级失败刷机恢复方法
MMMMMMMNFB
MLE
RBE
SPL Nand Load!
U-Boot 2017.09-svn160617 (Jun 03 2024 - 14:24:42 +0800), Build: jenkins-Backend-BSP-CCI-14166
DRAM: 512 MiB
NAND: 128 MiB
env_nand_load:read nand env0 sucessful
env_nand_load:crc env0 sucessful
env_nand_load:read nand env1 sucessful
env_nand_load:crc env1 sucessful
In: uart@0x18400000
Out: uart@0x18400000
Err: uart@0x18400000
Net: eth0: ethernet@1b900000, eth1: ethernet@1b800000
Chip-mode : sec-chip
fy10p_env_check flash ok!!!
Hit ctrl+u to stop autoboot: 0
This program will upgrade software.
*******************************************************
* ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY! *
* Don't reset machine,or anything that interrupt it. *
* The upgrade process must finish in 10 minutes! *
* If this program fails,machine might be unusable, *
* and you will need to reflash again. *
* If you find this too risky,power off machine now. *
*******************************************************
Now press [u/U] key to upgrade software: u
File system error,please upgrade by TFTP
Please input ip address of device: 192.168.1.64
Please input ip address of upgrade server: 192.168.1.128
Confirm?(y/n): y
Loading file 'uImage' to addr 0x40008000...
Done
Verifying Bootlogo RSA ... OK
## Starting application at 0x5D600000 ...
hikbootlogo version ##169705+
hikbootlogo svnpath: baseline/trunk/bootloader/bootlogo@169705
start JPEG decode...
Display the Hik-bootlogo
Verifying RSA ... OK
bootargs [hkvs.logo2=] is not supported, please check.
uboot setup watchdog
## Booting kernel from Legacy Image at 40008000 ...
Image Name: Linux-4.9.138
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 5660572 Bytes = 5.4 MiB
Load Address: 40008000
Entry Point: 40008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
Starting kernel ...
mv: can't rename 'ubi*': No such file or directory
Starting udev: [ OK ]
Rramoops file has not been generated!
-1-[ 7.395398] dwceqos 1b900000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
route: SIOCADDRT: Network is unreachable
set ip_forward to 0
This program will download and upgrade software.
*******************************************************
* ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY! *
* Don't reset machine,or anything that interrupt it. *
* The upgrade process must finish in 10 minutes! *
* If this program fails,machine might be unusable, *
* and you will need to reflash again. *
* If you find this too risky,power off machine now. *
*******************************************************
ftp server not exit[-111]! 刷机开始...
################################ [ 8.000 MB]
################################ [16.000 MB]
################################ [24.000 MB]
################################ [32.000 MB]
#############
tftp transmit over,file size[37030532][35.322 MB].
Download digicap success
[headEx ]: offset is 460 size is 1024
[uImage ]: offset is 1484 size is 5441632
[start.sh ]: offset is 5443116 size is 12320
[sys_app.tar.lzma ]: offset is 5455436 size is 14479784
[gui_res.tar.lzma ]: offset is 19935220 size is 2702472
[i18n.tar.lzma ]: offset is 22637692 size is 128
[webs.tar.lzma ]: offset is 22637820 size is 14391648
[CK ]: offset is 37029468 size is 448
[fac_check.bin ]: offset is 37029916 size is 360
RSA verifying ... OK
headEx checkSum ok !
uImage checkSum ok !
start.sh checkSum ok !
sys_app.tar.lzma checkSum ok !
gui_res.tar.lzma checkSum ok !
i18n.tar.lzma checkSum ok !
webs.tar.lzma checkSum ok !
CK checkSum ok !
fac_check.bin checkSum ok !
*******************************************************
* ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY ! *
* Don't power off or anything that interrupt it ! *
* The upgrade process will finish in 3 minutes ! *
* If this program fails, machine might be unusable ! *
*******************************************************
mount: mounting /dev/ubi2_0 on /dav2 failed: No such file or directory
umount: can't unmount /dav2: No such file or directory
Erasing cfg file ... Done
Writing ...
dav0-9-1. write headEx len: 1024
dav0-9-2. write uImage len: 5441632
dav0-9-3. write start.sh len: 12320
dav0-9-4. write sys_app.tar.lzma len: 14479784
dav0-9-5. write gui_res.tar.lzma len: 2702472
dav0-9-6. write i18n.tar.lzma len: 128
dav0-9-7. write webs.tar.lzma len: 14391648
dav0-9-8. write CK len: 448
dav0-9-9. write fac_check.bin len: 360
dav0-9-9. write flag file /dav0/version.bin len: 4
Done
Checking ...
Done
Erased [sata_startup_check] is Failed or not exist, please Check
Update successfully !系统BIOS成功更新了
Press ENTER key to reboot 回车重启期间五分钟不要断电
刷机后状态为未激活。
V4.76.015_240125 此版本可刷机
V4.83.015_build250212 此版本可刷机
2025.5.3用户测试成功
2025.5.3用户测试成功
